Kenwood TKR UHF Base Station/Repeater, MHz, W. Includes : DC Power Cable, rack handles and hardware, DC power supply adjustable. VHF/UHF FM Repeater-Base Units. General Features. 19″ Rack Mount Design; Primary DC Input Connector; Auto-Switched Back-Up DC Input Connector. TKR contains many Programmable Functions tabled below. Programmable cable, E, which is available from the KENWOOD parts center.
|Published (Last):||23 January 2005|
|PDF File Size:||10.5 Mb|
|ePub File Size:||3.81 Mb|
|Price:||Free* [*Free Regsitration Required]|
I have given it a 4 as I have only owned it for a few months, so it has very low run time, but so far it has performed well. Some of them are the first version 1. The repeaters can be setup ready to go with or without a controller.
I have tried many other models of controllers and found that the RLC-4 and the Kenwood mated together are a perfect match. We’ve had 6 of the UHF Kenwoods in service for a regional health care system primarily at local hospitals since and all feeding into a common hub repeater. It was installed about 4 years ago and hasn’t skipped a beat. Skip to main content.
Recently removed from active service in Ham bands. See condition above for more details.
It was slightly modified to work in the HAM band, but the front end was adjusted to compensate. If your looking for something other than a Motorola, this is a great repeater at the fraction of the cost.
This has been tested and working. Kenwood TKR Repeater in very good conditions and fully working. What you see is what you get. The repeater has been installed in a high RF zone with great performance giving me dBm RX out of the box.
Been running perfectly since then. kenowod
If you have any questions, problems, ,enwood suggestions about Reviews, please email your Reviews Manager. Number of bids and bid amounts may be slightly out of date. Includes item s seen in picture s. Krnwood a very good GMRS repeater. I have tried this out and can ta All of the repeaters are the TKRK. Including all spare parts My Subscriptions Subscriptions Help. No failures to date in a busy continuous duty system. Power and receivers have been checked.
The new version includes more DTMF remote control feature then the older v1 repeaters I have used in the past. This item will be sold “as-is” in used condition. I have more than 18 of these repeaters in HAM repeater use. Also shop in Also shop in.
If you find one of the first version repeaters they had a recall on the PA board and it was a dirrect replacement and is easy to install. This repeater along with the duplexer has been tested and calibrated with an IFR service monitor; it has a pair of frequencies tkd-850 with DCS Digital Tonethe RX side has excellent sensiti You can always knewood an outboard controller to the included serial port.
Kenwood UHF repeaters removed from service. Not a MTR, but for a fraction of the price, the performance specs are very close. Hats Off to Kenwood for doing a superb job in putting such a great machine together! Super easy to set up.
Kenwood TKR: Two-Way Radios | eBay
All new quality materials. Up for sale is: Contact the site with comments or questions. As this item is not new, its is not covered by any warranty, and is being sold as is. After looking to buy a used machine and rebuild, I decided to just buy a new one.
Email Subscription You are not subscribed to this review. Our club has a TKR V2. These cables are not fused. Being kewood Kenwood Dealer i make special deals for clubs and hams. You can disable it via the internal controller but if someone is jamming your repeater its nice to come in on a full duplex link or external receiver. Morse code IDs are attenuated if tkr-80 repeater is in us Sure, the repeater has a basic fkr-850 and it does a terrific job. You can toggle the Kenwood outbound tone to drop when inbound tone drops – nice feature.
All IDs are “polite”. Browse Related Browse Related. Buy 5 and Get 6th unit free. We matched the TKRs and several s to the Arcom controller. If the selection was available on kensood site for a better rating I would kenwod it at a 4. The exciter is operating 10 watts out into my PA delivering a nice signal with outstanding audio! The controller is very basic, but it will satisfy the minimum requirements.